Table

Three- and Four-Point Saddle Bend Table

Three- and Four-Point Saddle Bend Table reference with assumptions and boundary notes.

Reference boundary

Geometry reference only. It does not replace field layout marks or raceway bend limits.

Reference table

Compare saddle bend angle sets and multipliers for common conduit layout patterns.

Formula basis uses the same offset multiplier relationship: multiplier = 1 / sin(angle).
Saddle patternAngle setOffset multiplierUse
Three-point22.5 / 45 / 22.52.613Compact saddle around a small obstruction
Three-point30 / 60 / 302Common training and layout reference
Four-point30 / 30 / 30 / 302Two matching offsets with straight section between
Four-point45 / 45 / 45 / 451.414Shorter travel where bend radius and pull plan allow
Use notes
  • Use this table for preliminary reference and arithmetic checks only.
  • Confirm equipment ratings, product markings, installation conditions, utility requirements, and the local authority requirements before design or field use.